Elphel NC393L - Open Hardware Cameras for hackers.

From 33C3_Public_Wiki
Jump to: navigation, search
Description Building robotics, UAV navigation, medical imaging, document scanning, photofinishing, stereo and panoramic and even cinematographic cameras.

Apply for a sponsored camera !

Slides
Website(s) http://www.elphel.com/, http://blog.elphel.com/, http://wiki.elphel.com/
Tags innovation, fpga, hardware, software, community, medicine, open science, diy, sensor, hacking, engineering, real-time, robotics
Person organizing Polto
Contact: polto@alsenet.com
Language en - English
en - English
Duration 5
Desired session Day 4
Desired timeframe middle, end

refresh

Elphel NC393L - Open Hardware Cameras for hackers. Building robotics, UAV navigation, medical imaging, document scanning, photofinishing, stereo and panoramic and even cinematographic cameras.

Apply for a sponsored camera ! Describe your project and timeline on Elphel's wiki and e-mail me.

33c3 presentation slides

You can download the presentation slides

Operating System

Processor

  • Xilinx Zynq 7030 SoC
    • Dual-core ARM Cortex-A9 + FPGA
    • 800MHz

Supported Image Sensors

Memory and Storage

  • 1.0 GB DDR3 memory - system RAM
  • 0.5 GB DDR3 memory - FPGA RAM
  • 1.0 GB NAND flash - program storage
  • microSD card slot - storage and system recovery

Interfaces

  • Gigabit ethernet
  • micro USB - system console (serial port), reboot, select boot device
  • 4x sensor ports - routed to FPGA, each reconfigurable for general multi-purpose use
  • Added by [10389 Extension board]:
    • USB2.0 (host)
    • eSATA + USB port
    • M.2 SATA port
    • External synchronization (master or slave):
      • 2.5mm audio
      • 4-conductor flex cable
    • 2x 10-conductor flex cable ports
      • carry 3.3VDC, 5VDC, USB, I2C and GPIO
      • support other extension boards ([IMU], [GPS])